- TURN OFF your internet connection!  ( for setup and activation only. after finish activation you can use internet )

- Insert a USB-memory stick with at least 1MB free space!

- SETUP software ( start.exe ) ,

- write product id ( for cars : a-710-479 ) , ( for trucks : a-710-254 )

- Write the S/N and Hardware Key ( for Cars : serial number; 30250, HW key;  MNZTTOOCNHVE  )
                                                    ( for Trucks : serial number; 39071, HW key;  PUKRJOIVQTYX )
- contine

- click ON '' Activate via USB ''

- Insert a USB-memory stick with at least 1MB free space

- and you will have the '' FileActivation.xml '' file in USB-memory stick

- Post this FileActivation.xml file to me [ obdcartool@hotmail.com]

then i will send you new a FileActivation.xml file., copy into USB-memory stick .
and connect to USB-memory stick to computer. software wll get infos in. 
if not you can slect to manuel mode and open xml file

eject to usb-memory

software wll open then wll have an error ( Failed to load vehicle ...... )
close software

run '' Update_3_-_2011_Release_3 '' , write product id ( for cars : a-710-479 ) , ( for trucks : a-710-254 )
then next

sofware wll open !!

if you used alreday old verison autocom, for use interface you need make frimware update:
connect OBD2 interface to car .( for power )
setting , hw test , it wll have a message ask about frimware update . clict to ok and it wll make frimware update.
you need wait few minute for frimware update.( when is make frimware update ,dont close software or dont remove power ,etc )
then you can use autocom 2011 release3

Autocom  Car cables    Autocom  Truck cables

Autocom CDP Pro TRUCKS    AutoCom CDP Pro CARS